Midea error codes

Indoor unit codes

Midea E5

Indoor coil sensor T2 open or short

Inventor U6RSL multi split (Midea-built)

Ranges
  • M2OH / M3OE multi
  • Lamps: run lamp blinks 6×, timer lamp off

Likely causes

Sensor, indoor PCB.

First checks

Measure the sensor's resistance against its R-T table → replace the sensor or the PCB.

Source: Inventor Multi Split Unit Service Manual V:1.0.062022, p. 31

Inventor U6RSL multi split (Midea-built)

Ranges
  • M2OH / M3OE multi

Voltage protection (low AC voltage or high DC bus voltage)

Likely causes

Supply, bridge rectifier, IPM board.

First checks

Measure L–N: 220–240 V → check that the DC voltage P–N is in range → check the bridge rectifier → the IPM board → the main board.

Source: Inventor Multi Split Unit Service Manual V:1.0.062022, p. 46

Midea – old 2-character codes (about 2017–2019)

Ranges
  • Oasis Plus 2018
  • Indoor unit
  • Lamps: run lamp blinks 6×, timer lamp off

Likely causes

Sensor, its connector, indoor PCB.

First checks

Check the connector; measure the sensor's resistance against its table; sampling voltage below 0.06 V or above 4.94 V = fault → sensor, else PCB.

Source: Oasis Plus 3D Inverter Series 2018 Service Manual, R32, p. 67

In the app you also find codes by the model number on the nameplate, and Diagnose judges your readings.

Open in the appAll Midea error codes